1,2,3! That is how easy it is to copy a DVD or a CD with the Addonics family of DigiCopier! You can copy any DVD or CD without a computer. All you need to do is place the master into the source drive located on the top of the unit and a blank media into the rest of the other drives below the source drive. Close all the drive doors and start the copying process, and within a few minutes your DVD or CD is copied.

Designed to take advantage of the high performance SATA technologies, all Addonics Digicopiers are equipped with the latest high speed SATA optical drives that are available in the market. There are choices of four models to offer disc duplication of 1 copy, 3 copies, up to 7 copies or 11 copies at one time depending on your volume requirement. Each model is equipped with a user friendly LCM control module that provides a rich set of option configuration choices.

About this model

This DVD/CD DigiCopier VII allows you make up to seven copies of DVD or CD disc all at one time. An eSATA port is also available on the back of the  DigiCopier for attaching an optional external eSATA hard drive. With the additional of an eSATA hard drive, DVD or CD image can be copied onto the hard drive to use as a source. You can store as many images as needed depending on the capacity of your hard drive. By using the hard drive as a source, all optical drives in the Digicopier are now available to use as the target drive, further increasing the copying capacity to as many as eight disc at one time.

Operation illustration (1:3 DVD/CD Digicopier is shown)

• Copy up to seven DVD or CD disc at one time
• Operate as stand alone appliance. No computer required
• User-friendly interface and intuitive message display on the LCM control module
• High speed 24X SATA DVD/CDRW drive for maximum throughput
• Support copying* of CD, DVD, or DVD dual layer disc
• High-speed simultaneous recording
• Copy per cycle completes in as little as 6 minutes or less for a 4.5G DVD source image when copying onto 16X DVD media.
• Built-in eSATA port on the back for attaching an optional 3.5" or 2.5" eSATA hard drive to use as the source drive for storing disk images (.ISO format). When using the eSATA hard drive as the source drive, all optical drives in the unit can be used as target drives to increase copying capacity
• Edit track feature collects audio tracks on a number of CDs and merges them onto a single CD compilation (or a partition on the optional external eSATA hard drive)
• LCM control module provides a rich set of robust advanced configuration options
• firmware update using DVD-ROM disc
• 110/240V universal power supply for worldwide use

*Note: copy protected media may not duplicate successfully.