|
Home > Support >
Drivers Download > CardBus
> New Install
Alternative Installation Procedures
If you encountered system locked up using our standard installation procedures
(most common with Window 98 SE, Sharp and Sony Notebook computers), please try
to reinstall using the procedures outlined below:
-
Before installing the CardBus driver, make sure the CardBus is not inserted
into the PC Card slot.
-
Boot up the system and insert the CardBus driver diskette into Floppy Drive A.
-
Click on the START button, then SETTINGs and open the CONTROL PANEL.
-
Click on the ADD NEW HARDWARE icon.
-
Click NEXT and NEXT again, the screen will say WINDOWS WILL NOW SEARCH FOR PNP
DEVICES, DO YOU WANT WINDOWS TO SEARCH FOR YOUR NEW HARDWARE.
-
Choose NO, I WANT TO SELECT THE HARDWARE FROM A LIST.
-
Click NEXT.
-
Select HARD DISK CONTROLLERS from the hardware list.
-
Click NEXT, then click HAVE DISK.
-
Type A:\Window95, then click OK.
-
Highlight ADDONICS CARDBUS IDE CONTROLLER, then click NEXT, NEXT and FINISH.
-
Shut down the system. Reboot the system with the CardBus inserted inside the PC
CARD slot. Make sure the DVD drive is connected to the other end of the CardBUS
cable and the Drive is powered on.
-
The initialization of the DVD drive may take up to 40 seconds. During this
time, mouse moving may be sluggish. After completing the initialization, a new
CD ROM drive icon should appear in the My Computer. The CD-ROM drive should now be ready for use.
|
