Firmware Update Section for NASU2

Latest firmware version number: NASU2FW54E0 L:1.20E

Download NASU2FW54E0 Firmware

This firmware update fixes the following issues:

  1. Samba bug fixed in windows7 and MAC OS X 10.6.0.1
  2. Add BT function of max peer per torrent in WEB.

 

Older firmware versions:

NASU2FW46A

  1. Buffer overflow issue as described here
  2. DHCP server log

NASU2FW41

  1. Fixed NTBackup slow performance on large files
  2. Incompatibility with FireFox and Safari browsers saving settings on the NAS Adapter administrative screen
  3. Inability to turn off FTP server


Firmware Update Instructions (text version)

  1. Disconnect the USB hard drive connected to the NAS adapter.
  2. Click on the Maintenance section of the NAS Adapter GUI.
  3. Under the Maintenance section, click on Browse to locate the loader file.
  4. Locate the loader32_1_20e.bin file provided by Addonics on your computer and double click on it.
  5. Verify that you wish to flash the loader file firmware by selecting "Update".
  6. Wait for the progress bar to complete at 100%. The NAS Adapter unit will reboot.
  7. Under the Maintenance section again, click on Browse to locate the actual firmware file.
  8. Locate the NASU2FW54E0.bin file provided by Addonics on your computer and double click on it.
  9. Verify that you wish to flash the firmware by selecting "Update".
  10. Wait for the progress bar to complete at 100%. Once the reboot completes, the firmware should have completed flashing.
  11. Close the current NAS web GUI.
  12. Run SDisk.jar again then click on "Connect" button to connect to the NAS web GUI.

    Note: Sometimes, the NAS adapter picks up another DHCP IP address from the network so if you try to login to the old IP, the username and password will not work.
  13. Check the Status section to verify that the new firmware name is showing up under the "Firmware Version".
  14. Connect back the USB hard drive to the NAS adapter. Refresh web GUI and verify under SMB section that users are displayed.

 

Note: If you cannot login back into the web GUI of the NAS adapter follow the steps below:

  1. Disconnect the USB hard drive connected to the NAS. Use the procedure below to reset the NAS.
  2. While the NAS adapter is powered on, press the reset button with a paper clip and keep that position.
  3. Disconnect the power cable and reconnect the power after 5 seconds.
  4. After 30 seconds release the reset button.
  5. Since this will reset the NAS to factory defaults, you can change back the name of the NAS, the network and the IP address. Once this is done, you can connect back the USB hard drive and check in SAMBA that all the users are there.


Firmware Update Instructions (flash version)