The RAID Tower V is built basing on the Storage Tower V platform that features five 5.25" drive bays in a sturdy steel frame and compact chassis with an acrylic front bezel. Depending on the model, up to eight 3.5" hard drives can be installed into the RAID Tower V. The drives can be configured as a RAID set or as individual drives and be connected to the computer via the high speed eSATA or USB 3.0/2.0connection. Each model comes with everything needed for connecting to the computer. All is needed is to add your own hard drives and configure the RAID via either a simple on board rotary switch or onboard jumpers/software utility depending on the model of the RAID Tower.
The RT55SNHXU3 supports up to five SATA 3.5" drives. Using the Snap-In Mobile Rack, drives are added or removed like tape cartridge from each drive bay with no special tool required. It connects to the system via superspeed USB 3.0 or eSATA port using HPM-XA.
The RT55SNHX supports up to five SATA 3.5" drives. Using the Snap-In Mobile Rack, drives are added or removed like tape cartridge from each drive bay with no special tool required. It connects to the system via eSATA port using the HPM-XA.
The RT5835HEU3 supports up to eight SATA 3.5" drives. Using the Disk Array, drives are added or removed like tape cartridge from each drive bay with no special tool required. It connects to the system via two eSATA ports or USB 3.0/2.0 ports..
The RT54S2HMEU supports up to four SATA 3.5" drives and four SATA 2.5" drives. Using the Disk Array 5SA, drives are added or removed like tape cartridge from each drive bay with no special tool required. It connects to the system via eSATA port using 4x1 HPM.
The RT54S2HMEU supports up to eight SATA 3.5" drives. Using the Disk Array, drives are added or removed like tape cartridge from each drive bay with no special tool required. It connects to the system via two eSATA ports using two 4x1 HPM.
The RT55SN25HX supports up to 20 2.5" SATA/SSD drives with 4 eSATA ports on the back panel for connectivity. It supports RAID 0, 1, 10, 5, JBOD, and Clone mode. RAID is configured using RAID diagnostic software utility or onboard dip switches.
The RT55SN25ML supports up to 20 2.5" SATA/SSD drives through a single Multilane port on the back panel for connectivity. It supports RAID 0, 1, 10, 5, JBOD, and Clone mode. RAID is configured using RAID diagnostic software utility or onboard dip switches.
The RT55SN25SP supports up to 20 2.5" SATA/SSD drives with 4 eSATA ports on the back panel for connectivity. It supports RAID when connected onto a supported RAID host controller on the computer. Must be connected onto a port multiplier compatible controller.
